+ bitmap_set_bits
+ If the array has a write-intent bitmap, then writing to this
+ attribute can set bits in the bitmap, indicating that a resync
+ would need to check the corresponding blocks. Either individual
+ numbers or start-end pairs can be written. Multiple numbers
+ can be separated by a space.
+ Note that the numbers are 'bit' numbers, not 'block' numbers.
+ They should be scaled by the bitmap_chunksize.
+
+ sync_speed_min
+ sync_speed_max
+ This are similar to /proc/sys/dev/raid/speed_limit_{min,max}
+ however they only apply to the particular array.
+ If no value has been written to these, of if the word 'system'
+ is written, then the system-wide value is used. If a value,
+ in kibibytes-per-second is written, then it is used.
+ When the files are read, they show the currently active value
+ followed by "(local)" or "(system)" depending on whether it is
+ a locally set or system-wide value.
+
+ sync_completed
+ This shows the number of sectors that have been completed of
+ whatever the current sync_action is, followed by the number of
+ sectors in total that could need to be processed. The two
+ numbers are separated by a '/' thus effectively showing one
+ value, a fraction of the process that is complete.
+
+ sync_speed
+ This shows the current actual speed, in K/sec, of the current
+ sync_action. It is averaged over the last 30 seconds.
+
+ suspend_lo
+ suspend_hi
+ The two values, given as numbers of sectors, indicate a range
+ within the array where IO will be blocked. This is currently
+ only supported for raid4/5/6.
+
+