+
+config PHYSICAL_START
+ hex "Physical address where the kernel is loaded" if (EMBEDDED || CRASH_DUMP)
+
+ default "0x1000000" if CRASH_DUMP
+ default "0x100000"
+ help
+ This gives the physical address where the kernel is loaded. Normally
+ for regular kernels this value is 0x100000 (1MB). But in the case
+ of kexec on panic the fail safe kernel needs to run at a different
+ address than the panic-ed kernel. This option is used to set the load
+ address for kernels used to capture crash dump on being kexec'ed
+ after panic. The default value for crash dump kernels is
+ 0x1000000 (16MB). This can also be set based on the "X" value as
+ specified in the "crashkernel=YM@XM" command line boot parameter
+ passed to the panic-ed kernel. Typically this parameter is set as
+ crashkernel=64M@16M. Please take a look at
+ Documentation/kdump/kdump.txt for more details about crash dumps.
+
+ Don't change this unless you know what you are doing.
+
+config HOTPLUG_CPU
+ bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
+ depends on SMP && HOTPLUG && EXPERIMENTAL && !X86_VOYAGER
+ ---help---
+ Say Y here to experiment with turning CPUs off and on. CPUs
+ can be controlled through /sys/devices/system/cpu.
+
+ Say N.
+
+config DOUBLEFAULT
+ default y
+ bool "Enable doublefault exception handler" if EMBEDDED
+ help
+ This option allows trapping of rare doublefault exceptions that
+ would otherwise cause a system to silently reboot. Disabling this
+ option saves about 4k and might cause you much additional grey
+ hair.
+