SliceCOM adapter user's documentation - for the 0.51 driver version
-Written by Bartók István <bartoki@itc.hu>
+Written by Bartók István <bartoki@itc.hu>
-English translation: Lakatos György <gyuri@itc.hu>
+English translation: Lakatos György <gyuri@itc.hu>
Mon Dec 11 15:28:42 CET 2000
Last modified: Wed Aug 29 17:25:37 CEST 2001
- - no frame-sync, no signal received, or signal SNAFU.
- on "Everything is OK"
-on on Recepion is ok, but the remote end sends Remote Alarm
+on on Reception is ok, but the remote end sends Remote Alarm
on - The interface is unconfigured
-----------------------------------------------------------------
Though the options below are to be set on a single interface, they apply to the
whole board. The restriction, to use them on 'UP' interfaces, is because the
-command sequence below could lead to unpredicable results.
+command sequence below could lead to unpredictable results.
# echo 0 >boardnum
# echo internal >clock_source
// No alarms - Everything OK
//
// LOS - Loss Of Signal - No signal sensed on the input
-// AIS - Alarm Indication Signal - The remot side sends '11111111'-s,
+// AIS - Alarm Indication Signal - The remote side sends '11111111'-s,
// it tells, that there's an error condition, or it's not
// initialised.
// AUXP - Auxiliary Pattern Indication - 01010101.. received.
// LFA - Loss of Frame Alignment - no frame sync received.
-// RRA - Receive Remote Alarm - the remote end's OK, but singnals error cond.
+// RRA - Receive Remote Alarm - the remote end's OK, but signals error cond.
// LMFA - Loss of CRC4 Multiframe Alignment - no CRC4 multiframe sync.
// NMF - No Multiframe alignment Found after 400 msec - no such alarm using
// no-crc4 or crc4 framing, see below.
# echo >lbireg 0x1d 0x21
- - Swithing the loop off:
+ - Switching the loop off:
# echo >lbireg 0x1d 0x00