Pull motherboard into release branch

[powerpc.git] / arch / arm / mach-at91rm9200 / board-ek.c

diff --git a/arch/arm/mach-at91rm9200/board-ek.c b/arch/arm/mach-at91rm9200/board-ek.c
index d140645..80d90f5 100644 (file)
--- a/arch/arm/mach-at91rm9200/board-ek.c
+++ b/arch/arm/mach-at91rm9200/board-ek.c
@@ -70,6 +70,9 @@ static void __init ek_map_io(void)
        /* Initialize clocks: 18.432 MHz crystal */
        at91_clock_init(18432000);
 
+       /* Setup the LEDs */
+       at91_init_leds(AT91_PIN_PB1, AT91_PIN_PB2);
+
 #ifdef CONFIG_SERIAL_AT91
        at91_console_port = EK_SERIAL_CONSOLE;
        memcpy(at91_serial_map, serial, sizeof(serial));
@@ -111,16 +114,20 @@ static void __init ek_board_init(void)
        at91_add_device_usbh(&ek_usbh_data);
        /* USB Device */
        at91_add_device_udc(&ek_udc_data);
+#ifdef CONFIG_MTD_AT91_DATAFLASH_CARD
+       /* DataFlash card */
+       at91_set_gpio_output(AT91_PIN_PB22, 0);
+#else
        /* MMC */
-       at91_set_gpio_output(AT91_PIN_PB22, 1); /* this MMC card slot can optionally use SPI signaling (CS3). default: MMC */
+       at91_set_gpio_output(AT91_PIN_PB22, 1); /* this MMC card slot can optionally use SPI signaling (CS3). */
        at91_add_device_mmc(&ek_mmc_data);
+#endif
        /* VGA */
 //     ek_add_device_video();
 }
 
 MACHINE_START(AT91RM9200EK, "Atmel AT91RM9200-EK")
        /* Maintainer: SAN People/Atmel */
-       .phys_ram       = AT91_SDRAM_BASE,
        .phys_io        = AT91_BASE_SYS,
        .io_pg_offst    = (AT91_VA_BASE_SYS >> 18) & 0xfffc,
        .boot_params    = AT91_SDRAM_BASE + 0x100,