* any particular GDT layout, because we load our own as soon as we
* can.
*/
+.section .text.head,"ax",@progbits
ENTRY(startup_32)
#ifdef CONFIG_PARAVIRT
jb 10b
movl %edi,(init_pg_tables_end - __PAGE_OFFSET)
-#ifdef CONFIG_SMP
xorl %ebx,%ebx /* This is the boot CPU (BSP) */
jmp 3f
-
/*
* Non-boot CPU entry point; entered from trampoline.S
* We can't lgdt here, because lgdt itself uses a data segment, but
* we know the trampoline has already loaded the boot_gdt_table GDT
* for us.
+ *
+ * If cpu hotplug is not supported then this code can go in init section
+ * which will be freed later
*/
+
+#ifdef CONFIG_HOTPLUG_CPU
+.section .text,"ax",@progbits
+#else
+.section .init.text,"ax",@progbits
+#endif
+
+#ifdef CONFIG_SMP
ENTRY(startup_32_smp)
cld
movl $(__BOOT_DS),%eax
xorl %ebx,%ebx
incl %ebx
-3:
#endif /* CONFIG_SMP */
+3:
/*
* Enable paging
call check_x87
call setup_pda
- lgdt cpu_gdt_descr
+ lgdt early_gdt_descr
lidt idt_descr
ljmp $(__KERNEL_CS),$1f
1: movl $(__KERNEL_DS),%eax # reload all the segment registers
movl start_pda, %eax
/* slot the PDA address into the GDT */
- mov cpu_gdt_descr+2, %ecx
+ mov early_gdt_descr+2, %ecx
mov %ax, (__KERNEL_PDA+0+2)(%ecx) /* base & 0x0000ffff */
shr $16, %eax
mov %al, (__KERNEL_PDA+4+0)(%ecx) /* base & 0x00ff0000 */
#endif
iret
+.section .text
#ifdef CONFIG_PARAVIRT
startup_paravirt:
cld
pushl %ecx
pushl %eax
- /* paravirt.o is last in link, and that probe fn never returns */
pushl $__start_paravirtprobe
1:
movl 0(%esp), %eax
+ cmpl $__stop_paravirtprobe, %eax
+ je unhandled_paravirt
pushl (%eax)
movl 8(%esp), %eax
call *(%esp)
addl $4, (%esp)
jmp 1b
+
+unhandled_paravirt:
+ /* Nothing wanted us: we're screwed. */
+ ud2
#endif
/*
# boot GDT descriptor (later on used by CPU#0):
.word 0 # 32 bit align gdt_desc.address
-ENTRY(cpu_gdt_descr)
+ENTRY(early_gdt_descr)
.word GDT_ENTRIES*8-1
.long cpu_gdt_table