#include "libata.h"
+/**
+ * ata_irq_on - Enable interrupts on a port.
+ * @ap: Port on which interrupts are enabled.
+ *
+ * Enable interrupts on a legacy IDE device using MMIO or PIO,
+ * wait for idle, clear any pending interrupts.
+ *
+ * LOCKING:
+ * Inherited from caller.
+ */
+u8 ata_irq_on(struct ata_port *ap)
+{
+ struct ata_ioports *ioaddr = &ap->ioaddr;
+ u8 tmp;
+
+ ap->ctl &= ~ATA_NIEN;
+ ap->last_ctl = ap->ctl;
+
+ if (ap->flags & ATA_FLAG_MMIO)
+ writeb(ap->ctl, (void __iomem *) ioaddr->ctl_addr);
+ else
+ outb(ap->ctl, ioaddr->ctl_addr);
+ tmp = ata_wait_idle(ap);
+
+ ap->ops->irq_clear(ap);
+
+ return tmp;
+}
+
/**
* ata_tf_load_pio - send taskfile registers to host controller
* @ap: Port to which output is sent
writeb(ap->ctl, (void __iomem *)ioaddr->ctl_addr);
else
outb(ap->ctl, ioaddr->ctl_addr);
+
+ /* Under certain circumstances, some controllers raise IRQ on
+ * ATA_NIEN manipulation. Also, many controllers fail to mask
+ * previously pending IRQ on ATA_NIEN assertion. Clear it.
+ */
+ ata_chk_status(ap);
+
+ ap->ops->irq_clear(ap);
}
/**
ata_reset_fn_t softreset, ata_reset_fn_t hardreset,
ata_postreset_fn_t postreset)
{
- struct ata_eh_context *ehc = &ap->eh_context;
struct ata_queued_cmd *qc;
unsigned long flags;
int thaw = 0;
qc->tf.protocol == ATA_PROT_ATAPI_DMA)) {
u8 host_stat;
- host_stat = ata_bmdma_status(ap);
-
- ata_ehi_push_desc(&ehc->i, "BMDMA stat 0x%x", host_stat);
+ host_stat = ap->ops->bmdma_status(ap);
/* BMDMA controllers indicate host bus error by
* setting DMA_ERR bit and timing out. As it wasn't
*/
void ata_bmdma_post_internal_cmd(struct ata_queued_cmd *qc)
{
- ata_bmdma_stop(qc);
+ if (qc->ap->ioaddr.bmdma_addr)
+ ata_bmdma_stop(qc);
}
#ifdef CONFIG_PCI
pci_resource_start(pdev, 1) | ATA_PCI_CTL_OFS;
bmdma = pci_resource_start(pdev, 4);
if (bmdma) {
- if (inb(bmdma + 2) & 0x80)
+ if ((!(port[p]->flags & ATA_FLAG_IGN_SIMPLEX)) &&
+ (inb(bmdma + 2) & 0x80))
probe_ent->_host_flags |= ATA_HOST_SIMPLEX;
probe_ent->port[p].bmdma_addr = bmdma;
}
bmdma = pci_resource_start(pdev, 4);
if (bmdma) {
bmdma += 8;
- if(inb(bmdma + 2) & 0x80)
+ if ((!(port[p]->flags & ATA_FLAG_IGN_SIMPLEX)) &&
+ (inb(bmdma + 2) & 0x80))
probe_ent->_host_flags |= ATA_HOST_SIMPLEX;
probe_ent->port[p].bmdma_addr = bmdma;
}
return NULL;
probe_ent->n_ports = 2;
+ probe_ent->irq_flags = IRQF_SHARED;
if (port_mask & ATA_PORT_PRIMARY) {
- probe_ent->irq = ATA_PRIMARY_IRQ;
+ probe_ent->irq = ATA_PRIMARY_IRQ(pdev);
probe_ent->port[0].cmd_addr = ATA_PRIMARY_CMD;
probe_ent->port[0].altstatus_addr =
probe_ent->port[0].ctl_addr = ATA_PRIMARY_CTL;
if (bmdma) {
probe_ent->port[0].bmdma_addr = bmdma;
- if (inb(bmdma + 2) & 0x80)
+ if ((!(port[0]->flags & ATA_FLAG_IGN_SIMPLEX)) &&
+ (inb(bmdma + 2) & 0x80))
probe_ent->_host_flags |= ATA_HOST_SIMPLEX;
}
ata_std_ports(&probe_ent->port[0]);
if (port_mask & ATA_PORT_SECONDARY) {
if (probe_ent->irq)
- probe_ent->irq2 = ATA_SECONDARY_IRQ;
+ probe_ent->irq2 = ATA_SECONDARY_IRQ(pdev);
else
- probe_ent->irq = ATA_SECONDARY_IRQ;
+ probe_ent->irq = ATA_SECONDARY_IRQ(pdev);
probe_ent->port[1].cmd_addr = ATA_SECONDARY_CMD;
probe_ent->port[1].altstatus_addr =
probe_ent->port[1].ctl_addr = ATA_SECONDARY_CTL;
if (bmdma) {
probe_ent->port[1].bmdma_addr = bmdma + 8;
- if (inb(bmdma + 10) & 0x80)
+ if ((!(port[1]->flags & ATA_FLAG_IGN_SIMPLEX)) &&
+ (inb(bmdma + 10) & 0x80))
probe_ent->_host_flags |= ATA_HOST_SIMPLEX;
}
ata_std_ports(&probe_ent->port[1]);
#endif
}
- rc = pci_request_regions(pdev, DRV_NAME);
- if (rc) {
- disable_dev_on_err = 0;
- goto err_out;
- }
-
- if (legacy_mode) {
+ if (!legacy_mode) {
+ rc = pci_request_regions(pdev, DRV_NAME);
+ if (rc) {
+ disable_dev_on_err = 0;
+ goto err_out;
+ }
+ } else {
+ /* Deal with combined mode hack. This side of the logic all
+ goes away once the combined mode hack is killed in 2.6.21 */
if (!request_region(ATA_PRIMARY_CMD, 8, "libata")) {
struct resource *conflict, res;
res.start = ATA_PRIMARY_CMD;
}
} else
legacy_mode |= ATA_PORT_SECONDARY;
+
+ if (legacy_mode & ATA_PORT_PRIMARY)
+ pci_request_region(pdev, 1, DRV_NAME);
+ if (legacy_mode & ATA_PORT_SECONDARY)
+ pci_request_region(pdev, 3, DRV_NAME);
+ /* If there is a DMA resource, allocate it */
+ pci_request_region(pdev, 4, DRV_NAME);
}
/* we have legacy mode, but all ports are unavailable */
err_out_ent:
kfree(probe_ent);
err_out_regions:
- if (legacy_mode & ATA_PORT_PRIMARY)
- release_region(ATA_PRIMARY_CMD, 8);
- if (legacy_mode & ATA_PORT_SECONDARY)
- release_region(ATA_SECONDARY_CMD, 8);
- pci_release_regions(pdev);
+ /* All this conditional stuff is needed for the combined mode hack
+ until 2.6.21 when it can go */
+ if (legacy_mode) {
+ pci_release_region(pdev, 4);
+ if (legacy_mode & ATA_PORT_PRIMARY) {
+ release_region(ATA_PRIMARY_CMD, 8);
+ pci_release_region(pdev, 1);
+ }
+ if (legacy_mode & ATA_PORT_SECONDARY) {
+ release_region(ATA_SECONDARY_CMD, 8);
+ pci_release_region(pdev, 3);
+ }
+ } else
+ pci_release_regions(pdev);
err_out:
if (disable_dev_on_err)
pci_disable_device(pdev);
projects / powerpc.git / blobdiff