#define DRV_NAME "pata_it821x"
-#define DRV_VERSION "0.3.4"
+#define DRV_VERSION "0.3.6"
struct it821x_dev
{
static int it8212_noraid;
-/**
- * it821x_pre_reset - probe
- * @ap: ATA port
- *
- * Set the cable type
- */
-
-static int it821x_pre_reset(struct ata_port *ap)
-{
- ap->cbl = ATA_CBL_PATA80;
- return ata_std_prereset(ap);
-}
-
-/**
- * it821x_error_handler - probe/reset
- * @ap: ATA port
- *
- * Set the cable type and trigger a probe
- */
-
-static void it821x_error_handler(struct ata_port *ap)
-{
- return ata_bmdma_drive_eh(ap, it821x_pre_reset, ata_std_softreset, NULL, ata_std_postreset);
-}
-
/**
* it821x_program - program the PIO/MWDMA registers
* @ap: ATA port
/**
* it821x_dev_config - Called each device identify
- * @ap: ATA port
* @adev: Device that has just been identified
*
* Perform the initial setup needed for each device that is chip
* basically we need to filter commands for this chip.
*/
-static void it821x_dev_config(struct ata_port *ap, struct ata_device *adev)
+static void it821x_dev_config(struct ata_device *adev)
{
unsigned char model_num[ATA_ID_PROD_LEN + 1];
.freeze = ata_bmdma_freeze,
.thaw = ata_bmdma_thaw,
- .error_handler = it821x_error_handler,
+ .error_handler = ata_bmdma_error_handler,
.post_internal_cmd = ata_bmdma_post_internal_cmd,
+ .cable_detect = ata_cable_unknown,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.freeze = ata_bmdma_freeze,
.thaw = ata_bmdma_thaw,
- .error_handler = it821x_error_handler,
+ .error_handler = ata_bmdma_error_handler,
.post_internal_cmd = ata_bmdma_post_internal_cmd,
+ .cable_detect = ata_cable_unknown,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = it821x_passthru_bmdma_start,