and changed files

[powerpc.git] / drivers / ata / pata_jmicron.c

diff --git a/drivers/ata/pata_jmicron.c b/drivers/ata/pata_jmicron.c
index 47d0f94..1daf78a 100644 (file)
--- a/drivers/ata/pata_jmicron.c
+++ b/drivers/ata/pata_jmicron.c
@@ -30,16 +30,17 @@ typedef enum {
 /**
  *     jmicron_pre_reset       -       check for 40/80 pin
  *     @ap: Port
+ *     @deadline: deadline jiffies for the operation
  *
  *     Perform the PATA port setup we need.
-
+ *
  *     On the Jmicron 361/363 there is a single PATA port that can be mapped
  *     either as primary or secondary (or neither). We don't do any policy
  *     and setup here. We assume that has been done by init_one and the
  *     BIOS.
  */
 
-static int jmicron_pre_reset(struct ata_port *ap)
+static int jmicron_pre_reset(struct ata_port *ap, unsigned long deadline)
 {
        struct pci_dev *pdev = to_pci_dev(ap->host->dev);
        u32 control;
@@ -102,7 +103,7 @@ static int jmicron_pre_reset(struct ata_port *ap)
                ap->cbl = ATA_CBL_SATA;
                break;
        }
-       return ata_std_prereset(ap);
+       return ata_std_prereset(ap, deadline);
 }
 
 /**
@@ -137,6 +138,10 @@ static struct scsi_host_template jmicron_sht = {
        .slave_destroy          = ata_scsi_slave_destroy,
        /* Use standard CHS mapping rules */
        .bios_param             = ata_std_bios_param,
+#ifdef CONFIG_PM
+       .suspend                = ata_scsi_device_suspend,
+       .resume                 = ata_scsi_device_resume,
+#endif
 };
 
 static const struct ata_port_operations jmicron_ops = {
@@ -225,8 +230,10 @@ static struct pci_driver jmicron_pci_driver = {
        .id_table               = jmicron_pci_tbl,
        .probe                  = jmicron_init_one,
        .remove                 = ata_pci_remove_one,
+#ifdef CONFIG_PM
        .suspend                = ata_pci_device_suspend,
        .resume                 = ata_pci_device_resume,
+#endif
 };
 
 static int __init jmicron_init(void)