#define DRIVERNAPI "-NAPI"
#endif
#define DRV_VERSION "7.3.20-k2"DRIVERNAPI
-char e1000_driver_version[] = DRV_VERSION;
-static char e1000_copyright[] = "Copyright (c) 1999-2006 Intel Corporation.";
+const char e1000_driver_version[] = DRV_VERSION;
+static const char e1000_copyright[] = "Copyright (c) 1999-2006 Intel Corporation.";
/* e1000_pci_tbl - PCI Device ID Table
*
static int e1000_ioctl(struct net_device *netdev, struct ifreq *ifr, int cmd);
static int e1000_mii_ioctl(struct net_device *netdev, struct ifreq *ifr,
int cmd);
-void e1000_set_ethtool_ops(struct net_device *netdev);
static void e1000_enter_82542_rst(struct e1000_adapter *adapter);
static void e1000_leave_82542_rst(struct e1000_adapter *adapter);
static void e1000_tx_timeout(struct net_device *dev);
static void e1000_netpoll (struct net_device *netdev);
#endif
-extern void e1000_check_options(struct e1000_adapter *adapter);
-
#define COPYBREAK_DEFAULT 256
static unsigned int copybreak __read_mostly = COPYBREAK_DEFAULT;
module_param(copybreak, uint, 0644);
int i, err, pci_using_dac;
uint16_t eeprom_data = 0;
uint16_t eeprom_apme_mask = E1000_EEPROM_APME;
+ DECLARE_MAC_BUF(mac);
+
if ((err = pci_enable_device(pdev)))
return err;
"32-bit"));
}
- for (i = 0; i < 6; i++)
- printk("%2.2x%c", netdev->dev_addr[i], i == 5 ? '\n' : ':');
+ printk("%s\n", print_mac(mac, netdev->dev_addr));
/* reset the hardware with the new settings */
e1000_reset(adapter);
unsigned int first, max_per_txd = E1000_MAX_DATA_PER_TXD;
unsigned int max_txd_pwr = E1000_MAX_TXD_PWR;
unsigned int tx_flags = 0;
- unsigned int len = skb->len;
+ unsigned int len = skb->len - skb->data_len;
unsigned long flags;
- unsigned int nr_frags = 0;
- unsigned int mss = 0;
+ unsigned int nr_frags;
+ unsigned int mss;
int count = 0;
int tso;
unsigned int f;
- len -= skb->data_len;
/* This goes back to the question of how to logically map a tx queue
* to a flow. Right now, performance is impacted slightly negatively
* points to just header, pull a few bytes of payload from
* frags into skb->data */
hdr_len = skb_transport_offset(skb) + tcp_hdrlen(skb);
- if (skb->data_len && (hdr_len == (skb->len - skb->data_len))) {
+ if (skb->data_len && hdr_len == len) {
switch (adapter->hw.mac_type) {
unsigned int pull_size;
case e1000_82544:
spin_lock_irqsave(&adapter->stats_lock, flags);
- /* these counters are modified from e1000_adjust_tbi_stats,
+ /* these counters are modified from e1000_tbi_adjust_stats,
* called from the interrupt context, so they must only
* be written while holding adapter->stats_lock
*/
&work_done, budget);
/* If no Tx and not enough Rx work done, exit the polling mode */
- if ((!tx_cleaned && (work_done < budget)) ||
+ if ((!tx_cleaned && (work_done == 0)) ||
!netif_running(poll_dev)) {
quit_polling:
if (likely(adapter->itr_setting & 3))
spin_unlock_irqrestore(&adapter->stats_lock, flags);
return -EIO;
}
+ spin_unlock_irqrestore(&adapter->stats_lock, flags);
if (adapter->hw.media_type == e1000_media_type_copper) {
switch (data->reg_num) {
case PHY_CTRL:
DUPLEX_HALF;
retval = e1000_set_spd_dplx(adapter,
spddplx);
- if (retval) {
- spin_unlock_irqrestore(
- &adapter->stats_lock,
- flags);
+ if (retval)
return retval;
- }
}
if (netif_running(adapter->netdev))
e1000_reinit_locked(adapter);
break;
case M88E1000_PHY_SPEC_CTRL:
case M88E1000_EXT_PHY_SPEC_CTRL:
- if (e1000_phy_reset(&adapter->hw)) {
- spin_unlock_irqrestore(
- &adapter->stats_lock, flags);
+ if (e1000_phy_reset(&adapter->hw))
return -EIO;
- }
break;
}
} else {
break;
}
}
- spin_unlock_irqrestore(&adapter->stats_lock, flags);
break;
default:
return -EOPNOTSUPP;
pci_write_config_word(adapter->pdev, reg, *value);
}
+int
+e1000_pcix_get_mmrbc(struct e1000_hw *hw)
+{
+ struct e1000_adapter *adapter = hw->back;
+ return pcix_get_mmrbc(adapter->pdev);
+}
+
+void
+e1000_pcix_set_mmrbc(struct e1000_hw *hw, int mmrbc)
+{
+ struct e1000_adapter *adapter = hw->back;
+ pcix_set_mmrbc(adapter->pdev, mmrbc);
+}
+
int32_t
e1000_read_pcie_cap_reg(struct e1000_hw *hw, uint32_t reg, uint16_t *value)
{