#include <linux/module.h>
#include <linux/types.h>
#include <linux/pci.h>
+#include <linux/interrupt.h>
+
#include "shpchp.h"
#ifdef DEBUG
return;
}
+static inline int shpc_wait_cmd(struct controller *ctrl)
+{
+ int retval = 0;
+ unsigned int timeout_msec = shpchp_poll_mode ? 2000 : 1000;
+ unsigned long timeout = msecs_to_jiffies(timeout_msec);
+ int rc = wait_event_interruptible_timeout(ctrl->queue,
+ !ctrl->cmd_busy, timeout);
+ if (!rc) {
+ retval = -EIO;
+ err("Command not completed in %d msec\n", timeout_msec);
+ } else if (rc < 0) {
+ retval = -EINTR;
+ info("Command was interrupted by a signal\n");
+ }
+ ctrl->cmd_busy = 0;
+
+ return retval;
+}
+
static int shpc_write_cmd(struct slot *slot, u8 t_slot, u8 cmd)
{
struct php_ctlr_state_s *php_ctlr = slot->ctrl->hpc_ctlr_handle;
/* To make sure the Controller Busy bit is 0 before we send out the
* command.
*/
+ slot->ctrl->cmd_busy = 1;
writew(temp_word, php_ctlr->creg + CMD);
+ /*
+ * Wait for command completion.
+ */
+ retval = shpc_wait_cmd(slot->ctrl);
+
DBG_LEAVE_ROUTINE
return retval;
}
sec_bus_status = readw(php_ctlr->creg + SEC_BUS_CONFIG);
if (pi == 2) {
- *mode = (sec_bus_status & 0x0100) >> 7;
+ *mode = (sec_bus_status & 0x0100) >> 8;
} else {
retval = -1;
}
}
if (php_ctlr->pci_dev) {
iounmap(php_ctlr->creg);
- release_mem_region(pci_resource_start(php_ctlr->pci_dev, 0), pci_resource_len(php_ctlr->pci_dev, 0));
+ release_mem_region(ctrl->mmio_base, ctrl->mmio_size);
php_ctlr->pci_dev = NULL;
}
if (intr_loc & 0x0001) {
/*
* Command Complete Interrupt Pending
- * RO only - clear by writing 0 to the Command Completion
+ * RO only - clear by writing 1 to the Command Completion
* Detect bit in Controller SERR-INT register
*/
temp_dword = readl(php_ctlr->creg + SERR_INTR_ENABLE);
- temp_dword &= 0xfffeffff;
+ temp_dword &= 0xfffdffff;
writel(temp_dword, php_ctlr->creg + SERR_INTR_ENABLE);
+ ctrl->cmd_busy = 0;
wake_up_interruptible(&ctrl->queue);
}
int retval = 0;
u8 pi;
u32 slot_avail1, slot_avail2;
- int slot_num;
DBG_ENTER_ROUTINE
slot_avail2 = readl(php_ctlr->creg + SLOT_AVAIL2);
if (pi == 2) {
- if ((slot_num = ((slot_avail2 & SLOT_133MHZ_PCIX_533) >> 27) ) != 0 )
+ if (slot_avail2 & SLOT_133MHZ_PCIX_533)
bus_speed = PCIX_133MHZ_533;
- else if ((slot_num = ((slot_avail2 & SLOT_100MHZ_PCIX_533) >> 23) ) != 0 )
+ else if (slot_avail2 & SLOT_100MHZ_PCIX_533)
bus_speed = PCIX_100MHZ_533;
- else if ((slot_num = ((slot_avail2 & SLOT_66MHZ_PCIX_533) >> 19) ) != 0 )
+ else if (slot_avail2 & SLOT_66MHZ_PCIX_533)
bus_speed = PCIX_66MHZ_533;
- else if ((slot_num = ((slot_avail2 & SLOT_133MHZ_PCIX_266) >> 15) ) != 0 )
+ else if (slot_avail2 & SLOT_133MHZ_PCIX_266)
bus_speed = PCIX_133MHZ_266;
- else if ((slot_num = ((slot_avail2 & SLOT_100MHZ_PCIX_266) >> 11) ) != 0 )
+ else if (slot_avail2 & SLOT_100MHZ_PCIX_266)
bus_speed = PCIX_100MHZ_266;
- else if ((slot_num = ((slot_avail2 & SLOT_66MHZ_PCIX_266) >> 7) ) != 0 )
+ else if (slot_avail2 & SLOT_66MHZ_PCIX_266)
bus_speed = PCIX_66MHZ_266;
- else if ((slot_num = ((slot_avail1 & SLOT_133MHZ_PCIX) >> 23) ) != 0 )
+ else if (slot_avail1 & SLOT_133MHZ_PCIX)
bus_speed = PCIX_133MHZ;
- else if ((slot_num = ((slot_avail1 & SLOT_100MHZ_PCIX) >> 15) ) != 0 )
+ else if (slot_avail1 & SLOT_100MHZ_PCIX)
bus_speed = PCIX_100MHZ;
- else if ((slot_num = ((slot_avail1 & SLOT_66MHZ_PCIX) >> 7) ) != 0 )
+ else if (slot_avail1 & SLOT_66MHZ_PCIX)
bus_speed = PCIX_66MHZ;
- else if ((slot_num = (slot_avail2 & SLOT_66MHZ)) != 0 )
+ else if (slot_avail2 & SLOT_66MHZ)
bus_speed = PCI_66MHZ;
- else if ((slot_num = (slot_avail1 & SLOT_33MHZ)) != 0 )
+ else if (slot_avail1 & SLOT_33MHZ)
bus_speed = PCI_33MHZ;
else bus_speed = PCI_SPEED_UNKNOWN;
} else {
- if ((slot_num = ((slot_avail1 & SLOT_133MHZ_PCIX) >> 23) ) != 0 )
+ if (slot_avail1 & SLOT_133MHZ_PCIX)
bus_speed = PCIX_133MHZ;
- else if ((slot_num = ((slot_avail1 & SLOT_100MHZ_PCIX) >> 15) ) != 0 )
+ else if (slot_avail1 & SLOT_100MHZ_PCIX)
bus_speed = PCIX_100MHZ;
- else if ((slot_num = ((slot_avail1 & SLOT_66MHZ_PCIX) >> 7) ) != 0 )
+ else if (slot_avail1 & SLOT_66MHZ_PCIX)
bus_speed = PCIX_66MHZ;
- else if ((slot_num = (slot_avail2 & SLOT_66MHZ)) != 0 )
+ else if (slot_avail2 & SLOT_66MHZ)
bus_speed = PCI_66MHZ;
- else if ((slot_num = (slot_avail1 & SLOT_33MHZ)) != 0 )
+ else if (slot_avail1 & SLOT_33MHZ)
bus_speed = PCI_33MHZ;
else bus_speed = PCI_SPEED_UNKNOWN;
}
.check_cmd_status = hpc_check_cmd_status,
};
+inline static int shpc_indirect_creg_read(struct controller *ctrl, int index,
+ u32 *value)
+{
+ int rc;
+ u32 cap_offset = ctrl->cap_offset;
+ struct pci_dev *pdev = ctrl->pci_dev;
+
+ rc = pci_write_config_byte(pdev, cap_offset + DWORD_SELECT, index);
+ if (rc)
+ return rc;
+ return pci_read_config_dword(pdev, cap_offset + DWORD_DATA, value);
+}
+
int shpc_init(struct controller * ctrl, struct pci_dev * pdev)
{
struct php_ctlr_state_s *php_ctlr, *p;
void *instance_id = ctrl;
- int rc;
+ int rc, num_slots = 0;
u8 hp_slot;
static int first = 1;
- u32 shpc_cap_offset, shpc_base_offset;
+ u32 shpc_base_offset;
u32 tempdword, slot_reg;
u8 i;
DBG_ENTER_ROUTINE
+ ctrl->pci_dev = pdev; /* pci_dev of the P2P bridge */
+
spin_lock_init(&list_lock);
php_ctlr = (struct php_ctlr_state_s *) kmalloc(sizeof(struct php_ctlr_state_s), GFP_KERNEL);
if ((pdev->vendor == PCI_VENDOR_ID_AMD) || (pdev->device ==
PCI_DEVICE_ID_AMD_GOLAM_7450)) {
- shpc_base_offset = 0; /* amd shpc driver doesn't use this; assume 0 */
+ /* amd shpc driver doesn't use Base Offset; assume 0 */
+ ctrl->mmio_base = pci_resource_start(pdev, 0);
+ ctrl->mmio_size = pci_resource_len(pdev, 0);
} else {
- if ((shpc_cap_offset = pci_find_capability(pdev, PCI_CAP_ID_SHPC)) == 0) {
- err("%s : shpc_cap_offset == 0\n", __FUNCTION__);
+ ctrl->cap_offset = pci_find_capability(pdev, PCI_CAP_ID_SHPC);
+ if (!ctrl->cap_offset) {
+ err("%s : cap_offset == 0\n", __FUNCTION__);
goto abort_free_ctlr;
}
- dbg("%s: shpc_cap_offset = %x\n", __FUNCTION__, shpc_cap_offset);
-
- rc = pci_write_config_byte(pdev, (u8)shpc_cap_offset + DWORD_SELECT , BASE_OFFSET);
+ dbg("%s: cap_offset = %x\n", __FUNCTION__, ctrl->cap_offset);
+
+ rc = shpc_indirect_creg_read(ctrl, 0, &shpc_base_offset);
if (rc) {
- err("%s : pci_word_config_byte failed\n", __FUNCTION__);
+ err("%s: cannot read base_offset\n", __FUNCTION__);
goto abort_free_ctlr;
}
-
- rc = pci_read_config_dword(pdev, (u8)shpc_cap_offset + DWORD_DATA, &shpc_base_offset);
+
+ rc = shpc_indirect_creg_read(ctrl, 3, &tempdword);
if (rc) {
- err("%s : pci_read_config_dword failed\n", __FUNCTION__);
+ err("%s: cannot read slot config\n", __FUNCTION__);
goto abort_free_ctlr;
}
+ num_slots = tempdword & SLOT_NUM;
+ dbg("%s: num_slots (indirect) %x\n", __FUNCTION__, num_slots);
- for (i = 0; i <= 14; i++) {
- rc = pci_write_config_byte(pdev, (u8)shpc_cap_offset + DWORD_SELECT , i);
- if (rc) {
- err("%s : pci_word_config_byte failed\n", __FUNCTION__);
- goto abort_free_ctlr;
- }
-
- rc = pci_read_config_dword(pdev, (u8)shpc_cap_offset + DWORD_DATA, &tempdword);
+ for (i = 0; i < 9 + num_slots; i++) {
+ rc = shpc_indirect_creg_read(ctrl, i, &tempdword);
if (rc) {
- err("%s : pci_read_config_dword failed\n", __FUNCTION__);
+ err("%s: cannot read creg (index = %d)\n",
+ __FUNCTION__, i);
goto abort_free_ctlr;
}
dbg("%s: offset %d: value %x\n", __FUNCTION__,i,
tempdword);
}
+
+ ctrl->mmio_base =
+ pci_resource_start(pdev, 0) + shpc_base_offset;
+ ctrl->mmio_size = 0x24 + 0x4 * num_slots;
}
if (first) {
if (pci_enable_device(pdev))
goto abort_free_ctlr;
- if (!request_mem_region(pci_resource_start(pdev, 0) + shpc_base_offset, pci_resource_len(pdev, 0), MY_NAME)) {
+ if (!request_mem_region(ctrl->mmio_base, ctrl->mmio_size, MY_NAME)) {
err("%s: cannot reserve MMIO region\n", __FUNCTION__);
goto abort_free_ctlr;
}
- php_ctlr->creg = ioremap(pci_resource_start(pdev, 0) + shpc_base_offset, pci_resource_len(pdev, 0));
+ php_ctlr->creg = ioremap(ctrl->mmio_base, ctrl->mmio_size);
if (!php_ctlr->creg) {
- err("%s: cannot remap MMIO region %lx @ %lx\n", __FUNCTION__, pci_resource_len(pdev, 0),
- pci_resource_start(pdev, 0) + shpc_base_offset);
- release_mem_region(pci_resource_start(pdev, 0) + shpc_base_offset, pci_resource_len(pdev, 0));
+ err("%s: cannot remap MMIO region %lx @ %lx\n", __FUNCTION__,
+ ctrl->mmio_size, ctrl->mmio_base);
+ release_mem_region(ctrl->mmio_base, ctrl->mmio_size);
goto abort_free_ctlr;
}
dbg("%s: php_ctlr->creg %p\n", __FUNCTION__, php_ctlr->creg);
projects / powerpc.git / blobdiff