#undef DEBUG /* messages on error and most fault paths */
#undef VERBOSE /* extra debug messages (success too) */
-#include <linux/config.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/dma-mapping.h>
ep->stopped = 1;
set_halt (ep);
mode = 2;
- } else if (!req && ep->stopped)
+ } else if (!req && !ep->stopped)
write_fifo (ep, NULL);
}
} else {
/* if we wrote it all, we're usually done */
if (req->req.actual == req->req.length) {
if (ep->num == 0) {
- /* wait for control status */
- if (mode != 2)
- req = NULL;
+ /* send zlps until the status stage */
} else if (!req->req.zero || len != ep->ep.maxpacket)
mode = 2;
}
{
struct net2280 *dev = _dev;
+ /* shared interrupt, not ours */
+ if (!(readl(&dev->regs->irqstat0) & (1 << INTA_ASSERTED)))
+ return IRQ_NONE;
+
spin_lock (&dev->lock);
/* handle disconnect, dma, and more */
unsigned long resource, len;
void __iomem *base = NULL;
int retval, i;
- char buf [8], *bufp;
/* if you want to support more than one controller in a system,
* usb_gadget_driver_{register,unregister}() must change.
}
/* alloc, and start init */
- dev = kmalloc (sizeof *dev, SLAB_KERNEL);
+ dev = kzalloc (sizeof *dev, SLAB_KERNEL);
if (dev == NULL){
retval = -ENOMEM;
goto done;
}
- memset (dev, 0, sizeof *dev);
+ pci_set_drvdata (pdev, dev);
spin_lock_init (&dev->lock);
dev->pdev = pdev;
dev->gadget.ops = &net2280_ops;
retval = -ENODEV;
goto done;
}
-#ifndef __sparc__
- scnprintf (buf, sizeof buf, "%d", pdev->irq);
- bufp = buf;
-#else
- bufp = __irq_itoa(pdev->irq);
-#endif
- if (request_irq (pdev->irq, net2280_irq, SA_SHIRQ, driver_name, dev)
+
+ if (request_irq (pdev->irq, net2280_irq, IRQF_SHARED, driver_name, dev)
!= 0) {
- ERROR (dev, "request interrupt %s failed\n", bufp);
+ ERROR (dev, "request interrupt %d failed\n", pdev->irq);
retval = -EBUSY;
goto done;
}
dev->chiprev = get_idx_reg (dev->regs, REG_CHIPREV) & 0xffff;
/* done */
- pci_set_drvdata (pdev, dev);
INFO (dev, "%s\n", driver_desc);
- INFO (dev, "irq %s, pci mem %p, chip rev %04x\n",
- bufp, base, dev->chiprev);
+ INFO (dev, "irq %d, pci mem %p, chip rev %04x\n",
+ pdev->irq, base, dev->chiprev);
INFO (dev, "version: " DRIVER_VERSION "; dma %s\n",
use_dma
? (use_dma_chaining ? "chaining" : "enabled")
return retval;
}
+/* make sure the board is quiescent; otherwise it will continue
+ * generating IRQs across the upcoming reboot.
+ */
+
+static void net2280_shutdown (struct pci_dev *pdev)
+{
+ struct net2280 *dev = pci_get_drvdata (pdev);
+
+ /* disable IRQs */
+ writel (0, &dev->regs->pciirqenb0);
+ writel (0, &dev->regs->pciirqenb1);
+
+ /* disable the pullup so the host will think we're gone */
+ writel (0, &dev->usb->usbctl);
+}
+
/*-------------------------------------------------------------------------*/
.probe = net2280_probe,
.remove = net2280_remove,
+ .shutdown = net2280_shutdown,
/* FIXME add power management support */
};