config VIDEO_OUTPUT_CONTROL
tristate "Lowlevel video output switch controls"
- default m
help
This framework adds support for low-level control of the video
output switch.
help
This enables support for the Hecuba board. This driver was tested
with an E-Ink 800x600 display and x86 SBCs through a 16 bit GPIO
- interface (8 bit data, 4 bit control). If you anticpate using
+ interface (8 bit data, 4 bit control). If you anticipate using
this driver, say Y or M; otherwise say N. You must specify the
GPIO IO address to be used for setting control and data.
help
This is the framebuffer device for the Sun XVR-500 and similar
graphics cards based upon the 3DLABS Wildcat chipset. The driver
- only works on sparc64 systems where the system firwmare has
+ only works on sparc64 systems where the system firmware has
mostly initialized the card already. It is treated as a
completely dumb framebuffer device.
help
This is the framebuffer device for the Sun XVR-2500 and similar
graphics cards based upon the 3DLABS Wildcat chipset. The driver
- only works on sparc64 systems where the system firwmare has
+ only works on sparc64 systems where the system firmware has
mostly initialized the card already. It is treated as a
completely dumb framebuffer device.