imxfb: remove ifdefs

[powerpc.git] / drivers / video / imxfb.c

diff --git a/drivers/video/imxfb.c b/drivers/video/imxfb.c
index 267c1ff..6cdf269 100644 (file)
--- a/drivers/video/imxfb.c
+++ b/drivers/video/imxfb.c
@@ -394,26 +394,18 @@ static void imxfb_setup_gpio(struct imxfb_info *fbi)
 
        /* initialize GPIOs */
        imx_gpio_mode(PD6_PF_LSCLK);
-       imx_gpio_mode(PD10_PF_SPL_SPR);
        imx_gpio_mode(PD11_PF_CONTRAST);
        imx_gpio_mode(PD14_PF_FLM_VSYNC);
        imx_gpio_mode(PD13_PF_LP_HSYNC);
-       imx_gpio_mode(PD7_PF_REV);
-       imx_gpio_mode(PD8_PF_CLS);
-
-#ifndef CONFIG_MACH_PIMX1
-       /* on PiMX1 used as buffers enable signal
-        */
-       imx_gpio_mode(PD9_PF_PS);
-#endif
-
-#ifndef CONFIG_MACH_MX1FS2
-       /* on mx1fs2 this pin is used to (de)activate the display, so we need
-        * it as a normal gpio
-        */
        imx_gpio_mode(PD12_PF_ACD_OE);
-#endif
 
+       /* These are only needed for Sharp HR TFT displays */
+       if (fbi->pcr & PCR_SHARP) {
+               imx_gpio_mode(PD7_PF_REV);
+               imx_gpio_mode(PD8_PF_CLS);
+               imx_gpio_mode(PD9_PF_PS);
+               imx_gpio_mode(PD10_PF_SPL_SPR);
+       }
 }
 
 #ifdef CONFIG_PM
@@ -499,6 +491,7 @@ static int __init imxfb_init_fbinfo(struct device *dev)
        info->var.sync                  = inf->sync;
        info->var.grayscale             = inf->cmap_greyscale;
        fbi->cmap_inverse               = inf->cmap_inverse;
+       fbi->cmap_static                = inf->cmap_static;
        fbi->pcr                        = inf->pcr;
        fbi->lscr1                      = inf->lscr1;
        fbi->dmacr                      = inf->dmacr;