//! Initialize registers and all that jazz.
void init(){
+ #ifdef DAC12IR
int i;
+ #endif
+
WDTCTL = WDTPW + WDTHOLD; // Stop watchdog timer
//LED out and on.
PLEDDIR |= PLEDPIN;
PLEDOUT &= ~PLEDPIN;
+
+
+ /* P5.0 out and low; this is chosen for the PIC app (in which P5.0
+ is !MCLR) to ensure that an attached PIC chip, if present, is
+ immediately driven to reset state. A brief explanation of why this
+ is important follows.
+
+ At least dsPIC33F and PIC24H --and very likely other 16-bit PIC
+ families-- draw a large amount of current when running, especially
+ when using a fast clock: from 60 mA up to approx. 90 mA. If the
+ PIC target begins to run before the client can request a new ICSP
+ session, which requires much less current (e.g., less than 2 mA),
+ then the MSP430 chip on the GoodFET will fail to start and the FTDI
+ may have trouble communicating with the client. The latter likely
+ relates to the FTDI on-chip 3V3 regulator being specified up to
+ only 50 mA. */
+
+ P5DIR |= BIT0;
+ //P5REN &= ~BIT0; //DO NOT UNCOMMENT. Breaks GF1x support.
+ P5OUT &= ~BIT0;
//Setup clocks, unique to each '430.
msp430_init_dco();
unsigned char verb,
unsigned long len){
//debugstr("GoodFET");
- P1OUT&=~1;
+ PLEDOUT&=~PLEDPIN;
switch(app){
case GLITCH:
glitchhandle(app,verb,len);
case SPI:
spihandle(app,verb,len);
break;
+ case NRF:
+ nrfhandle(app,verb,len);
+ break;
+ case CCSPI:
+ ccspihandle(app,verb,len);
+ break;
case AVR:
avrhandle(app,verb,len);
break;
-#ifdef INSTALL_PIC_APP
case PIC:
pichandle(app,verb,len);
break;
-#endif
+
case I2CAPP:
i2chandle(app,verb,len);
break;
ejtaghandle(app,verb,len);
break;
case JTAG430: //Also JTAG430X, JTAG430X2
+ //Revert this when X2 support returns.
jtag430x2handle(app,verb,len);
+ //jtag430handle(app,verb,len);
break;
case SMARTCARD:
smartcardhandle(app,verb,len);