#ifndef _ASM_PARISC_ROPES_H_
#define _ASM_PARISC_ROPES_H_
+#include <asm-parisc/parisc-device.h>
+
#ifdef CONFIG_64BIT
/* "low end" PA8800 machines use ZX1 chipset: PAT PDC and only run 64-bit */
#define ZX1_SUPPORT
#endif
/*
-** The number of pdir entries to "free" before issueing
+** The number of pdir entries to "free" before issuing
** a read to PCOM register to flush out PCOM writes.
** Interacts with allocation granularity (ie 4 or 8 entries
** allocated and free'd/purged at a time might make this
return d->id.hversion == PLUTO_MCKINLEY_PORT;
}
-#define SBA_IOMMU_COOKIE 0x0000badbadc0ffeeUL
+#define PLUTO_IOVA_BASE (1UL*1024*1024*1024) /* 1GB */
+#define PLUTO_IOVA_SIZE (1UL*1024*1024*1024) /* 1GB */
+#define PLUTO_GART_SIZE (PLUTO_IOVA_SIZE / 2)
+
+#define SBA_PDIR_VALID_BIT 0x8000000000000000ULL
+
+#define SBA_AGPGART_COOKIE 0x0000badbadc0ffeeULL
+
+#define SBA_FUNC_ID 0x0000 /* function id */
+#define SBA_FCLASS 0x0008 /* function class, bist, header, rev... */
+
+#define SBA_FUNC_SIZE 4096 /* SBA configuration function reg set */
+
+#define ASTRO_IOC_OFFSET (32 * SBA_FUNC_SIZE)
+#define PLUTO_IOC_OFFSET (1 * SBA_FUNC_SIZE)
+/* Ike's IOC's occupy functions 2 and 3 */
+#define IKE_IOC_OFFSET(p) ((p+2) * SBA_FUNC_SIZE)
+
+#define IOC_CTRL 0x8 /* IOC_CTRL offset */
+#define IOC_CTRL_TC (1 << 0) /* TOC Enable */
+#define IOC_CTRL_CE (1 << 1) /* Coalesce Enable */
+#define IOC_CTRL_DE (1 << 2) /* Dillon Enable */
+#define IOC_CTRL_RM (1 << 8) /* Real Mode */
+#define IOC_CTRL_NC (1 << 9) /* Non Coherent Mode */
+#define IOC_CTRL_D4 (1 << 11) /* Disable 4-byte coalescing */
+#define IOC_CTRL_DD (1 << 13) /* Disable distr. LMMIO range coalescing */
+
+/*
+** Offsets into MBIB (Function 0 on Ike and hopefully Astro)
+** Firmware programs this stuff. Don't touch it.
+*/
+#define LMMIO_DIRECT0_BASE 0x300
+#define LMMIO_DIRECT0_MASK 0x308
+#define LMMIO_DIRECT0_ROUTE 0x310
+
+#define LMMIO_DIST_BASE 0x360
+#define LMMIO_DIST_MASK 0x368
+#define LMMIO_DIST_ROUTE 0x370
+
+#define IOS_DIST_BASE 0x390
+#define IOS_DIST_MASK 0x398
+#define IOS_DIST_ROUTE 0x3A0
+
+#define IOS_DIRECT_BASE 0x3C0
+#define IOS_DIRECT_MASK 0x3C8
+#define IOS_DIRECT_ROUTE 0x3D0
+
+/*
+** Offsets into I/O TLB (Function 2 and 3 on Ike)
+*/
+#define ROPE0_CTL 0x200 /* "regbus pci0" */
+#define ROPE1_CTL 0x208
+#define ROPE2_CTL 0x210
+#define ROPE3_CTL 0x218
+#define ROPE4_CTL 0x220
+#define ROPE5_CTL 0x228
+#define ROPE6_CTL 0x230
+#define ROPE7_CTL 0x238
+
+#define IOC_ROPE0_CFG 0x500 /* pluto only */
+#define IOC_ROPE_AO 0x10 /* Allow "Relaxed Ordering" */
+
+#define HF_ENABLE 0x40
+
+#define IOC_IBASE 0x300 /* IO TLB */
+#define IOC_IMASK 0x308
+#define IOC_PCOM 0x310
+#define IOC_TCNFG 0x318
+#define IOC_PDIR_BASE 0x320
+
+/*
+** IOC supports 4/8/16/64KB page sizes (see TCNFG register)
+** It's safer (avoid memory corruption) to keep DMA page mappings
+** equivalently sized to VM PAGE_SIZE.
+**
+** We really can't avoid generating a new mapping for each
+** page since the Virtual Coherence Index has to be generated
+** and updated for each page.
+**
+** PAGE_SIZE could be greater than IOVP_SIZE. But not the inverse.
+*/
+#define IOVP_SIZE PAGE_SIZE
+#define IOVP_SHIFT PAGE_SHIFT
+#define IOVP_MASK PAGE_MASK
+
+#define SBA_PERF_CFG 0x708 /* Performance Counter stuff */
+#define SBA_PERF_MASK1 0x718
+#define SBA_PERF_MASK2 0x730
+
+/*
+** Offsets into PCI Performance Counters (functions 12 and 13)
+** Controlled by PERF registers in function 2 & 3 respectively.
+*/
+#define SBA_PERF_CNT1 0x200
+#define SBA_PERF_CNT2 0x208
+#define SBA_PERF_CNT3 0x210
/*
** lba_device: Per instance Elroy data structure
return (d->id.hversion == QUICKSILVER_HVERS);
}
+static inline int agp_mode_mercury(void __iomem *hpa) {
+ u64 bus_mode;
+
+ bus_mode = readl(hpa + 0x0620);
+ if (bus_mode & 1)
+ return 1;
+
+ return 0;
+}
+
/*
** I/O SAPIC init function
** Caller knows where an I/O SAPIC is. LBA has an integrated I/O SAPIC.
extern void *iosapic_register(unsigned long hpa);
extern int iosapic_fixup_irq(void *obj, struct pci_dev *pcidev);
+#define LBA_FUNC_ID 0x0000 /* function id */
+#define LBA_FCLASS 0x0008 /* function class, bist, header, rev... */
+#define LBA_CAPABLE 0x0030 /* capabilities register */
+
+#define LBA_PCI_CFG_ADDR 0x0040 /* poke CFG address here */
+#define LBA_PCI_CFG_DATA 0x0048 /* read or write data here */
+
+#define LBA_PMC_MTLT 0x0050 /* Firmware sets this - read only. */
+#define LBA_FW_SCRATCH 0x0058 /* Firmware writes the PCI bus number here. */
+#define LBA_ERROR_ADDR 0x0070 /* On error, address gets logged here */
+
+#define LBA_ARB_MASK 0x0080 /* bit 0 enable arbitration. PAT/PDC enables */
+#define LBA_ARB_PRI 0x0088 /* firmware sets this. */
+#define LBA_ARB_MODE 0x0090 /* firmware sets this. */
+#define LBA_ARB_MTLT 0x0098 /* firmware sets this. */
+
+#define LBA_MOD_ID 0x0100 /* Module ID. PDC_PAT_CELL reports 4 */
+
+#define LBA_STAT_CTL 0x0108 /* Status & Control */
+#define LBA_BUS_RESET 0x01 /* Deassert PCI Bus Reset Signal */
+#define CLEAR_ERRLOG 0x10 /* "Clear Error Log" cmd */
+#define CLEAR_ERRLOG_ENABLE 0x20 /* "Clear Error Log" Enable */
+#define HF_ENABLE 0x40 /* enable HF mode (default is -1 mode) */
+
+#define LBA_LMMIO_BASE 0x0200 /* < 4GB I/O address range */
+#define LBA_LMMIO_MASK 0x0208
+
+#define LBA_GMMIO_BASE 0x0210 /* > 4GB I/O address range */
+#define LBA_GMMIO_MASK 0x0218
+
+#define LBA_WLMMIO_BASE 0x0220 /* All < 4GB ranges under the same *SBA* */
+#define LBA_WLMMIO_MASK 0x0228
+
+#define LBA_WGMMIO_BASE 0x0230 /* All > 4GB ranges under the same *SBA* */
+#define LBA_WGMMIO_MASK 0x0238
+
+#define LBA_IOS_BASE 0x0240 /* I/O port space for this LBA */
+#define LBA_IOS_MASK 0x0248
+
+#define LBA_ELMMIO_BASE 0x0250 /* Extra LMMIO range */
+#define LBA_ELMMIO_MASK 0x0258
+
+#define LBA_EIOS_BASE 0x0260 /* Extra I/O port space */
+#define LBA_EIOS_MASK 0x0268
+
+#define LBA_GLOBAL_MASK 0x0270 /* Mercury only: Global Address Mask */
+#define LBA_DMA_CTL 0x0278 /* firmware sets this */
+
+#define LBA_IBASE 0x0300 /* SBA DMA support */
+#define LBA_IMASK 0x0308
+
+/* FIXME: ignore DMA Hint stuff until we can measure performance */
+#define LBA_HINT_CFG 0x0310
+#define LBA_HINT_BASE 0x0380 /* 14 registers at every 8 bytes. */
+
+#define LBA_BUS_MODE 0x0620
+
+/* ERROR regs are needed for config cycle kluges */
+#define LBA_ERROR_CONFIG 0x0680
+#define LBA_SMART_MODE 0x20
+#define LBA_ERROR_STATUS 0x0688
+#define LBA_ROPE_CTL 0x06A0
+
+#define LBA_IOSAPIC_BASE 0x800 /* Offset of IRQ logic */
+
#endif /*_ASM_PARISC_ROPES_H_*/
projects / powerpc.git / blobdiff