#include <linux/workqueue.h>
#include <scsi/scsi_host.h>
+/*
+ * Define if arch has non-standard setup. This is a _PCI_ standard
+ * not a legacy or ISA standard.
+ */
+#ifdef CONFIG_ATA_NONSTANDARD
#include <asm/libata-portmap.h>
+#else
+#include <asm-generic/libata-portmap.h>
+#endif
/*
* compile-time options: to be removed as soon as all the drivers are
#define ATA_TAG_POISON 0xfafbfcfdU
/* move to PCI layer? */
+#define PCI_VDEVICE(vendor, device) \
+ PCI_VENDOR_ID_##vendor, (device), \
+ PCI_ANY_ID, PCI_ANY_ID, 0, 0
+
static inline struct device *pci_dev_to_dev(struct pci_dev *pdev)
{
return &pdev->dev;
ATA_DFLAG_LBA48 = (1 << 1), /* device supports LBA48 */
ATA_DFLAG_CDB_INTR = (1 << 2), /* device asserts INTRQ when ready for CDB */
ATA_DFLAG_NCQ = (1 << 3), /* device supports NCQ */
+ ATA_DFLAG_FLUSH_EXT = (1 << 4), /* do FLUSH_EXT instead of FLUSH */
ATA_DFLAG_CFG_MASK = (1 << 8) - 1,
- ATA_DFLAG_PIO = (1 << 8), /* device currently in PIO mode */
- ATA_DFLAG_SUSPENDED = (1 << 9), /* device suspended */
+ ATA_DFLAG_PIO = (1 << 8), /* device limited to PIO mode */
+ ATA_DFLAG_NCQ_OFF = (1 << 9), /* device limited to non-NCQ mode */
+ ATA_DFLAG_SUSPENDED = (1 << 10), /* device suspended */
ATA_DFLAG_INIT_MASK = (1 << 16) - 1,
ATA_DFLAG_DETACH = (1 << 16),
ATA_FLAG_SKIP_D2H_BSY = (1 << 12), /* can't wait for the first D2H
* Register FIS clearing BSY */
ATA_FLAG_DEBUGMSG = (1 << 13),
+ ATA_FLAG_SETXFER_POLLING= (1 << 14), /* use polling for SETXFER */
+ ATA_FLAG_IGN_SIMPLEX = (1 << 15), /* ignore SIMPLEX */
/* The following flag belongs to ap->pflags but is kept in
* ap->flags because it's referenced in many LLDs and will be
ATA_EHI_QUIET = (1 << 3), /* be quiet */
ATA_EHI_DID_RESET = (1 << 16), /* already reset this port */
+ ATA_EHI_PRINTINFO = (1 << 17), /* print configuration info */
+ ATA_EHI_SETMODE = (1 << 18), /* configure transfer mode */
+ ATA_EHI_POST_SETMODE = (1 << 19), /* revaildating after setmode */
ATA_EHI_RESET_MODIFIER_MASK = ATA_EHI_RESUME_LINK,
* most devices.
*/
ATA_SPINUP_WAIT = 8000,
+
+ /* Horkage types. May be set by libata or controller on drives
+ (some horkage may be drive/controller pair dependant */
+
+ ATA_HORKAGE_DIAGNOSTIC = (1 << 0), /* Failed boot diag */
+ ATA_HORKAGE_NODMA = (1 << 1), /* DMA problems */
+ ATA_HORKAGE_NONCQ = (1 << 2), /* Don't use NCQ */
};
enum hsm_task_states {
- HSM_ST_UNKNOWN, /* state unknown */
HSM_ST_IDLE, /* no command on going */
HSM_ST, /* (waiting the device to) transfer data */
HSM_ST_LAST, /* (waiting the device to) complete command */
AC_ERR_SYSTEM = (1 << 6), /* system error */
AC_ERR_INVALID = (1 << 7), /* invalid argument */
AC_ERR_OTHER = (1 << 8), /* unknown */
+ AC_ERR_NODEV_HINT = (1 << 9), /* polling device detection hint */
};
/* forward declarations */
unsigned long _host_flags;
void __iomem *mmio_base;
void *private_data;
+
+ /* port_info for the secondary port. Together with irq2, it's
+ * used to implement non-uniform secondary port. Currently,
+ * the only user is ata_piix combined mode. This workaround
+ * will be removed together with ata_probe_ent when init model
+ * is updated.
+ */
+ const struct ata_port_info *pinfo2;
};
struct ata_host {
/* error history */
struct ata_ering ering;
+ unsigned int horkage; /* List of broken features */
};
/* Offset into struct ata_device. Fields above it are maintained
struct ata_host *host;
struct device *dev;
- struct work_struct port_task;
- struct work_struct hotplug_task;
+ void *port_task_data;
+ struct delayed_work port_task;
+ struct delayed_work hotplug_task;
struct work_struct scsi_rescan_task;
unsigned int hsm_task_state;
void (*dev_select)(struct ata_port *ap, unsigned int device);
void (*phy_reset) (struct ata_port *ap); /* obsolete */
- void (*set_mode) (struct ata_port *ap);
+ int (*set_mode) (struct ata_port *ap, struct ata_device **r_failed_dev);
void (*post_set_mode) (struct ata_port *ap);
- int (*check_atapi_dma) (struct ata_queued_cmd *qc);
+ int (*check_atapi_dma) (struct ata_queued_cmd *qc);
void (*bmdma_setup) (struct ata_queued_cmd *qc);
void (*bmdma_start) (struct ata_queued_cmd *qc);
void (*error_handler) (struct ata_port *ap);
void (*post_internal_cmd) (struct ata_queued_cmd *qc);
- irqreturn_t (*irq_handler)(int, void *, struct pt_regs *);
+ irq_handler_t irq_handler;
void (*irq_clear) (struct ata_port *);
u32 (*scr_read) (struct ata_port *ap, unsigned int sc_reg);
extern int sata_phy_resume(struct ata_port *ap, const unsigned long *param);
extern int ata_std_prereset(struct ata_port *ap);
extern int ata_std_softreset(struct ata_port *ap, unsigned int *classes);
+extern int sata_port_hardreset(struct ata_port *ap,
+ const unsigned long *timing);
extern int sata_std_hardreset(struct ata_port *ap, unsigned int *class);
extern void ata_std_postreset(struct ata_port *ap, unsigned int *classes);
-extern int ata_dev_revalidate(struct ata_device *dev, int post_reset);
extern void ata_port_disable(struct ata_port *);
extern void ata_std_ports(struct ata_ioports *ioaddr);
#ifdef CONFIG_PCI
extern int ata_host_suspend(struct ata_host *host, pm_message_t mesg);
extern void ata_host_resume(struct ata_host *host);
extern int ata_ratelimit(void);
-extern unsigned int ata_busy_sleep(struct ata_port *ap,
- unsigned long timeout_pat,
- unsigned long timeout);
-extern void ata_port_queue_task(struct ata_port *ap, void (*fn)(void *),
+extern int ata_busy_sleep(struct ata_port *ap,
+ unsigned long timeout_pat, unsigned long timeout);
+extern void ata_port_queue_task(struct ata_port *ap, work_func_t fn,
void *data, unsigned long delay);
extern u32 ata_wait_register(void __iomem *reg, u32 mask, u32 val,
unsigned long interval_msec,
extern int ata_port_start (struct ata_port *ap);
extern void ata_port_stop (struct ata_port *ap);
extern void ata_host_stop (struct ata_host *host);
-extern irqreturn_t ata_interrupt (int irq, void *dev_instance, struct pt_regs *regs);
+extern irqreturn_t ata_interrupt (int irq, void *dev_instance);
extern void ata_mmio_data_xfer(struct ata_device *adev, unsigned char *buf,
unsigned int buflen, int write_data);
extern void ata_pio_data_xfer(struct ata_device *adev, unsigned char *buf,
unsigned int ofs, unsigned int len);
extern void ata_id_c_string(const u16 *id, unsigned char *s,
unsigned int ofs, unsigned int len);
+extern unsigned long ata_device_blacklisted(const struct ata_device *dev);
extern void ata_bmdma_setup (struct ata_queued_cmd *qc);
extern void ata_bmdma_start (struct ata_queued_cmd *qc);
extern void ata_bmdma_stop(struct ata_queued_cmd *qc);
udelay(10);
status = ata_chk_status(ap);
max--;
- } while ((status & bits) && (max > 0));
+ } while (status != 0xff && (status & bits) && (max > 0));
return status;
}
{
u8 status = ata_busy_wait(ap, ATA_BUSY | ATA_DRQ, 1000);
- if (status & (ATA_BUSY | ATA_DRQ)) {
+ if (status != 0xff && (status & (ATA_BUSY | ATA_DRQ))) {
unsigned long l = ap->ioaddr.status_addr;
if (ata_msg_warn(ap))
printk(KERN_WARNING "ATA: abnormal status 0x%X on port 0x%lX\n",
static inline void ata_qc_reinit(struct ata_queued_cmd *qc)
{
+ qc->dma_dir = DMA_NONE;
qc->__sg = NULL;
qc->flags = 0;
qc->cursect = qc->cursg = qc->cursg_ofs = 0;
qc->nsect = 0;
qc->nbytes = qc->curbytes = 0;
+ qc->n_elem = 0;
qc->err_mask = 0;
+ qc->pad_len = 0;
ata_tf_init(qc->dev, &qc->tf);
qc->result_tf.feature = 0;
}
-/**
- * ata_irq_on - Enable interrupts on a port.
- * @ap: Port on which interrupts are enabled.
- *
- * Enable interrupts on a legacy IDE device using MMIO or PIO,
- * wait for idle, clear any pending interrupts.
- *
- * LOCKING:
- * Inherited from caller.
- */
-
-static inline u8 ata_irq_on(struct ata_port *ap)
-{
- struct ata_ioports *ioaddr = &ap->ioaddr;
- u8 tmp;
-
- ap->ctl &= ~ATA_NIEN;
- ap->last_ctl = ap->ctl;
-
- if (ap->flags & ATA_FLAG_MMIO)
- writeb(ap->ctl, (void __iomem *) ioaddr->ctl_addr);
- else
- outb(ap->ctl, ioaddr->ctl_addr);
- tmp = ata_wait_idle(ap);
-
- ap->ops->irq_clear(ap);
-
- return tmp;
-}
-
-
/**
* ata_irq_ack - Acknowledge a device interrupt.
* @ap: Port on which interrupts are enabled.