#define TUNER_PHILIPS_TUV1236D 68 /* ATI HDTV Wonder */
#define TUNER_TNF_5335MF 69 /* Sabrent Bt848 */
-#define TUNER_SET_TYPE_ADDR _IOW('T',3,int)
-#define TUNER_SET_STANDBY _IOW('T',4,int)
-#define TDA9887_SET_CONFIG _IOW('t',5,int)
-
/* tv card specific */
#define TDA9887_PRESENT (1<<0)
#define TDA9887_PORT1_INACTIVE (1<<1)
T_STANDBY = 1 << 31
};
+/* Older boards only had a single tuner device. Nowadays multiple tuner
+ devices may be present on a single board. Using TUNER_SET_TYPE_ADDR
+ to pass the tuner_setup structure it is possible to setup each tuner
+ device in turn.
+
+ Since multiple devices may be present it is no longer sufficient to
+ send a command to a single i2c device. Instead you should broadcast
+ the command to all i2c devices.
+
+ By setting the mode_mask correctly you can select which commands are
+ accepted by a specific tuner device. For example, set mode_mask to
+ T_RADIO if the device is a radio-only tuner. That specific tuner will
+ only accept commands when the tuner is in radio mode and ignore them
+ when the tuner is set to TV mode.
+ */
+
struct tuner_setup {
- unsigned short addr;
- unsigned int type;
- unsigned int mode_mask;
+ unsigned short addr; /* I2C address */
+ unsigned int type; /* Tuner type */
+ unsigned int mode_mask; /* Allowed tuner modes */
};
struct tuner {
void (*standby)(struct i2c_client *c);
};
-extern unsigned int tuner_debug;
extern unsigned const int tuner_count;
extern int microtune_init(struct i2c_client *c);
#define tuner_warn(fmt, arg...) do {\
printk(KERN_WARNING "%s %d-%04x: " fmt, t->i2c.driver->driver.name, \
i2c_adapter_id(t->i2c.adapter), t->i2c.addr , ##arg); } while (0)
-
#define tuner_info(fmt, arg...) do {\
printk(KERN_INFO "%s %d-%04x: " fmt, t->i2c.driver->driver.name, \
i2c_adapter_id(t->i2c.adapter), t->i2c.addr , ##arg); } while (0)
#define tuner_dbg(fmt, arg...) do {\
+ extern int tuner_debug; \
if (tuner_debug) \
printk(KERN_DEBUG "%s %d-%04x: " fmt, t->i2c.driver->driver.name, \
i2c_adapter_id(t->i2c.adapter), t->i2c.addr , ##arg); } while (0)