X-Git-Url: http://git.rot13.org/?a=blobdiff_plain;f=Documentation%2Fcciss.txt;h=f74affe5c8297f58b4d36dfac566e7411899f2c5;hb=8f34f6cfa27ddae8faf10aef986db2fda1ba6791;hp=c8f9a73111da8371d5ff4b49b68116ffb3353e48;hpb=62778ba1aa2589dc78c36a32edc6f5a6ccaf50c6;p=powerpc.git

diff --git a/Documentation/cciss.txt b/Documentation/cciss.txt
index c8f9a73111..f74affe5c8 100644
--- a/Documentation/cciss.txt
+++ b/Documentation/cciss.txt
@@ -17,7 +17,10 @@ This driver is known to work with the following cards:
 	* SA P600
 	* SA P800
 	* SA E400
-	* SA E300
+	* SA P400i
+	* SA E200
+	* SA E200i
+	* SA E500
 
 If nodes are not already created in the /dev/cciss directory, run as root:
 
@@ -77,7 +80,7 @@ the /proc filesystem entry which the "block" side of the driver creates as
 the SCSI core may not yet be initialized (because the driver is a block 
 driver) and attempting to register it with the SCSI core in such a case 
 would cause a hang.  This is best done via an initialization script 
-(typically in /etc/init.d, but could vary depending on distibution). 
+(typically in /etc/init.d, but could vary depending on distribution). 
 For example:
 
 	for x in /proc/driver/cciss/cciss[0-9]*
@@ -131,3 +134,32 @@ hardware and it is important to prevent the kernel from attempting to directly
 access these devices too, as if the array controller were merely a SCSI 
 controller in the same way that we are allowing it to access SCSI tape drives.
 
+SCSI error handling for tape drives and medium changers
+-------------------------------------------------------
+
+The linux SCSI mid layer provides an error handling protocol which
+kicks into gear whenever a SCSI command fails to complete within a
+certain amount of time (which can vary depending on the command).
+The cciss driver participates in this protocol to some extent.  The
+normal protocol is a four step process.  First the device is told
+to abort the command.  If that doesn't work, the device is reset.
+If that doesn't work, the SCSI bus is reset.  If that doesn't work
+the host bus adapter is reset.  Because the cciss driver is a block
+driver as well as a SCSI driver and only the tape drives and medium
+changers are presented to the SCSI mid layer, and unlike more 
+straightforward SCSI drivers, disk i/o continues through the block
+side during the SCSI error recovery process, the cciss driver only
+implements the first two of these actions, aborting the command, and
+resetting the device.  Additionally, most tape drives will not oblige 
+in aborting commands, and sometimes it appears they will not even 
+obey a reset command, though in most circumstances they will.  In
+the case that the command cannot be aborted and the device cannot be 
+reset, the device will be set offline.
+
+In the event the error handling code is triggered and a tape drive is
+successfully reset or the tardy command is successfully aborted, the 
+tape drive may still not allow i/o to continue until some command
+is issued which positions the tape to a known position.  Typically you
+must rewind the tape (by issuing "mt -f /dev/st0 rewind" for example)
+before i/o can proceed again to a tape drive which was reset.
+