X-Git-Url: http://git.rot13.org/?a=blobdiff_plain;f=firmware%2Fapps%2Fglitch%2Fglitch.c;h=8b435940b76a52ed0fbf83c3275be2c43ced3f05;hb=32f1d645330835191ef4c3c3f9947e690196e768;hp=53b037682cfad9fee95abfbd4bf064979cc2d26a;hpb=f10e55ab25dfe0b4114a1700920a1433708e8fcd;p=goodfet

diff --git a/firmware/apps/glitch/glitch.c b/firmware/apps/glitch/glitch.c
index 53b0376..8b43594 100644
--- a/firmware/apps/glitch/glitch.c
+++ b/firmware/apps/glitch/glitch.c
@@ -30,6 +30,7 @@ void glitchsetup(){
   
   //Normal voltage, use resistors instead of output.
   //P5DIR=0x80;   //ONLY glitch pin is output.
+  P5DIR|=0x80;   //glitch pin is output.
   P5OUT|=0x80;  //It MUST begin high.
   //P5REN|=0x7F;  //Resistors pull high and low weakly.
   
@@ -46,9 +47,18 @@ void glitchsetup(){
 
 // Timer A0 interrupt service routine
 interrupt(TIMERA0_VECTOR) Timer_A (void){
+  //This oughtn't be necessary, but glitches repeat without it.
+  TACTL=0; //disable counter.
+  
+  
   P5OUT^=BIT7;//Glitch
-  //P5DIR=BIT7; //All else high impedance.
+  //asm("nop"); //delay deepens glitch.
   P5OUT^=BIT7;//Normal
+  
+  //This oughtn't be necessary, but glitches repeat without it.
+  TACTL=0; //disable counter.
+  
+  //P5OUT^=BIT7;//Normal
   return;
 }
 
@@ -128,13 +138,14 @@ void glitchhandle(unsigned char app,
     break;
   case START:
     //Testing mode, for looking at the glitch waveform.
-    glitchvoltages(0xFFF,0);//Inverted VCC and GND.
+    glitchvoltages(0,0xFFF);//Minimum glitch, for noise test.
+    //glitchvoltages(0,0);//Drop VCC
+    //glitchvoltages(0xFFF,0xFFF);//Raise Ground
     P5OUT|=BIT7;//Normal
     P5DIR|=BIT7;
     while(1){
       P5OUT&=~BIT7;//Glitch
-      //asm("nop");//asm("nop");asm("nop");asm("nop");asm("nop");asm("nop");
-      //asm("nop"); //Not necessary.
+      //asm("nop"); //Not Necessary
       P5OUT|=BIT7;//Normal
       asm("nop");asm("nop");asm("nop");asm("nop");asm("nop");asm("nop");
       asm("nop");asm("nop");asm("nop");asm("nop");asm("nop");asm("nop");