X-Git-Url: http://git.rot13.org/?a=blobdiff_plain;f=firmware%2Finclude%2Fplatform.h;h=44767241b9b793ef44a371146a98f015b85e7e62;hb=04a2b075b5f2a0e3fa8273f55f1e01b606084158;hp=014ea209dbba5f0265ff84cdc20e5f2c1efa6729;hpb=aabfeb9b5b2cb5609056f85a31b52d709cfcfda4;p=goodfet

diff --git a/firmware/include/platform.h b/firmware/include/platform.h
index 014ea20..4476724 100644
--- a/firmware/include/platform.h
+++ b/firmware/include/platform.h
@@ -1,21 +1,51 @@
 /*! \file platform.h
   \author Travis Goodspeed
   \brief Port and baud rate definitions.
-  
+
   The functions specified here are defined in the platform
   definition file, such as msp430x1612.c or msp430x2618.c.
 */
 
+#ifndef __PLATFORM_H
+#define __PLATFORM_H
+
+
 #include "gfports.h"
 
-#ifdef telosb
-//TelosB uses second serial port.
+#include <stdint.h>
+
+#ifdef MSP430
+ #ifdef __MSPGCC__
+  #include <msp430.h>
+ #else
+  #include <signal.h>
+  #include <msp430.h>
+  #include <iomacros.h>
+ #endif
+
+ void msp430_init();
+ void led_init();  //deprecated
+ void led_on();
+ void led_off();
+ void led_toggle();
+ #if defined telosb || defined apimote
+  void led2_on();
+  void led2_off();
+  void led3_on();
+  void led3_off();
+ #endif
+#endif
+
+#include "config.h"
+
+#ifdef useuart1
+//TelosB and the ApiMote use the second serial port.
 #define serial_tx serial1_tx
 #define serial_rx serial1_rx
 #define setbaud setbaud1
 #define msp430_init_uart msp430_init_uart1
 #else
-//Other targets use first.
+//Other targets use first uart.
 #define serial_tx serial0_tx
 #define serial_rx serial0_rx
 #define setbaud setbaud0
@@ -41,8 +71,6 @@ void msp430_init_dco();
 //! Called by monitor() when the DCO is correct and communication established.
 void msp430_init_dco_done();
 
-//LED on P1.0
-#define PLEDOUT P1OUT
-#define PLEDDIR P1DIR
-#define PLEDPIN BIT0
+
+#endif