$Conf{SmbClientPath} = '/usr/bin/smbclient';
#
-# Commands to run smbclient for a full dump, incremental dump or a restore.
+# Command to run smbclient for a full dump.
# This setting only matters if $Conf{XferMethod} = 'smb'.
#
# The following variables are substituted at run-time:
# $X_option exclude option (if $fileList is an exclude list)
# $timeStampFile start time for incremental dump
#
-# If your smb share is read-only then direct restores will fail.
-# You should set $Conf{SmbClientRestoreCmd} to undef and the
-# corresponding CGI restore option will be removed.
-#
$Conf{SmbClientFullCmd} = '$smbClientPath \\\\$host\\$shareName'
. ' $I_option -U $userName -E -N -d 1'
. ' -c tarmode\\ full -Tc$X_option - $fileList';
+#
+# Command to run smbclient for an incremental dump.
+# This setting only matters if $Conf{XferMethod} = 'smb'.
+#
+# Same variable substitutions are applied as $Conf{SmbClientFullCmd}.
+#
$Conf{SmbClientIncrCmd} = '$smbClientPath \\\\$host\\$shareName'
. ' $I_option -U $userName -E -N -d 1'
. ' -c tarmode\\ full -TcN$X_option $timeStampFile - $fileList';
+#
+# Command to run smbclient for a restore.
+# This setting only matters if $Conf{XferMethod} = 'smb'.
+#
+# Same variable substitutions are applied as $Conf{SmbClientFullCmd}.
+#
+# If your smb share is read-only then direct restores will fail.
+# You should set $Conf{SmbClientRestoreCmd} to undef and the
+# corresponding CGI restore option will be removed.
+#
$Conf{SmbClientRestoreCmd} = '$smbClientPath \\\\$host\\$shareName'
. ' $I_option -U $userName -E -N -d 1'
. ' -c tarmode\\ full -Tx -';
# If the value is 0, or if $Conf{ArchiveDest} is an existing file or
# device (e.g. a streaming tape drive), this feature is disabled.
#
-$Conf{ArchiveSplit} = 650;
+$Conf{ArchiveSplit} = 0;
#
# Archive Command
# $shares list of all the share names
# $XferMethod value of $Conf{XferMethod} (eg: tar, rsync, smb)
# $sshPath value of $Conf{SshPath},
+# $cmdType set to DumpPreUserCmd or DumpPostUserCmd
#
# The following variable substitutions are made at run time for
# $Conf{RestorePreUserCmd} and $Conf{RestorePostUserCmd}:
# $pathHdrSrc common starting path of restore source
# $pathHdrDest common starting path of destination
# $fileList list of files being restored
+# $cmdType set to RestorePreUserCmd or RestorePostUserCmd
#
# The following variable substitutions are made at run time for
# $Conf{ArchivePreUserCmd} and $Conf{ArchivePostUserCmd}:
# $splitsize size of the files that the archive creates
# $sshPath value of $Conf{SshPath},
# $type set to "archive"
+# $cmdType set to ArchivePreUserCmd or ArchivePostUserCmd
#
$Conf{DumpPreUserCmd} = undef;
$Conf{DumpPostUserCmd} = undef;