# BRCM_VERSION=3
[bcm963xx.git] / kernel / linux / arch / alpha / kernel / pci_impl.h
1 /*
2  *      linux/arch/alpha/kernel/pci_impl.h
3  *
4  * This file contains declarations and inline functions for interfacing
5  * with the PCI initialization routines.
6  */
7
8 struct pci_dev;
9 struct pci_controller;
10 struct pci_iommu_arena;
11
12 /*
13  * We can't just blindly use 64K for machines with EISA busses; they
14  * may also have PCI-PCI bridges present, and then we'd configure the
15  * bridge incorrectly.
16  *
17  * Also, we start at 0x8000 or 0x9000, in hopes to get all devices'
18  * IO space areas allocated *before* 0xC000; this is because certain
19  * BIOSes (Millennium for one) use PCI Config space "mechanism #2"
20  * accesses to probe the bus. If a device's registers appear at 0xC000,
21  * it may see an INx/OUTx at that address during BIOS emulation of the
22  * VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense.
23  */
24
25 #define EISA_DEFAULT_IO_BASE    0x9000  /* start above 8th slot */
26 #define DEFAULT_IO_BASE         0x8000  /* start at 8th slot */
27
28 /*
29  * We try to make the DEFAULT_MEM_BASE addresses *always* have more than
30  * a single bit set. This is so that devices like the broken Myrinet card
31  * will always have a PCI memory address that will never match a IDSEL
32  * address in PCI Config space, which can cause problems with early rev cards.
33  */
34
35 /*
36  * An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address
37  * that get passed through the PCI<->ISA bridge chip. Although this causes
38  * us to set the PCI->Mem window bases lower than normal, we still allocate
39  * PCI bus devices' memory addresses *below* the low DMA mapping window,
40  * and hope they fit below 64Mb (to avoid conflicts), and so that they can
41  * be accessed via SPARSE space.
42  *
43  * We accept the risk that a broken Myrinet card will be put into a true XL
44  * and thus can more easily run into the problem described below.
45  */
46 #define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */
47
48 /*
49  * APECS and LCA have only 34 bits for physical addresses, thus limiting PCI
50  * bus memory addresses for SPARSE access to be less than 128Mb.
51  */
52 #define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024)
53
54 /*
55  * Because MCPCIA and T2 core logic support more bits for
56  * physical addresses, they should allow an expanded range of SPARSE
57  * memory addresses.  However, we do not use them all, in order to
58  * avoid the HAE manipulation that would be needed.
59  */
60 #define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
61 #define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024)
62
63 /*
64  * Because CIA and PYXIS have more bits for physical addresses,
65  * they support an expanded range of SPARSE memory addresses.
66  */
67 #define DEFAULT_MEM_BASE ((128+16)*1024*1024)
68
69 /* ??? Experimenting with no HAE for CIA.  */
70 #define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
71
72 #define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024)
73
74 #define DEFAULT_AGP_APER_SIZE   (64*1024*1024)
75
76 /* 
77  * A small note about bridges and interrupts.  The DECchip 21050 (and
78  * later) adheres to the PCI-PCI bridge specification.  This says that
79  * the interrupts on the other side of a bridge are swizzled in the
80  * following manner:
81  *
82  * Dev    Interrupt   Interrupt 
83  *        Pin on      Pin on 
84  *        Device      Connector
85  *
86  *   4    A           A
87  *        B           B
88  *        C           C
89  *        D           D
90  * 
91  *   5    A           B
92  *        B           C
93  *        C           D
94  *        D           A
95  *
96  *   6    A           C
97  *        B           D
98  *        C           A
99  *        D           B
100  *
101  *   7    A           D
102  *        B           A
103  *        C           B
104  *        D           C
105  *
106  *   Where A = pin 1, B = pin 2 and so on and pin=0 = default = A.
107  *   Thus, each swizzle is ((pin-1) + (device#-4)) % 4
108  *
109  *   The following code swizzles for exactly one bridge.  The routine
110  *   common_swizzle below handles multiple bridges.  But there are a
111  *   couple boards that do strange things, so we define this here.
112  */
113
114 static inline u8 bridge_swizzle(u8 pin, u8 slot) 
115 {
116         return (((pin-1) + slot) % 4) + 1;
117 }
118
119
120 /* The following macro is used to implement the table-based irq mapping
121    function for all single-bus Alphas.  */
122
123 #define COMMON_TABLE_LOOKUP                                             \
124 ({ long _ctl_ = -1;                                                     \
125    if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot)   \
126      _ctl_ = irq_tab[slot - min_idsel][pin];                            \
127    _ctl_; })
128
129
130 /* A PCI IOMMU allocation arena.  There are typically two of these
131    regions per bus.  */
132 /* ??? The 8400 has a 32-byte pte entry, and the entire table apparently
133    lives directly on the host bridge (no tlb?).  We don't support this
134    machine, but if we ever did, we'd need to parameterize all this quite
135    a bit further.  Probably with per-bus operation tables.  */
136
137 struct pci_iommu_arena
138 {
139         spinlock_t lock;
140         struct pci_controller *hose;
141 #define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */
142 #define IOMMU_RESERVED_PTE 0xface
143         unsigned long *ptes;
144         dma_addr_t dma_base;
145         unsigned int size;
146         unsigned int next_entry;
147         unsigned int align_entry;
148 };
149
150 #if defined(CONFIG_ALPHA_SRM) && \
151     (defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA))
152 # define NEED_SRM_SAVE_RESTORE
153 #else
154 # undef NEED_SRM_SAVE_RESTORE
155 #endif
156
157 #if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE)
158 # define ALPHA_RESTORE_SRM_SETUP
159 #else
160 # undef ALPHA_RESTORE_SRM_SETUP
161 #endif
162
163 #ifdef ALPHA_RESTORE_SRM_SETUP
164 /* Store PCI device configuration left by SRM here. */
165 struct pdev_srm_saved_conf
166 {
167         struct pdev_srm_saved_conf *next;
168         struct pci_dev *dev;
169         u32 regs[16];
170 };
171
172 extern void pci_restore_srm_config(void);
173 #else
174 #define pdev_save_srm_config(dev)       do {} while (0)
175 #define pci_restore_srm_config()        do {} while (0)
176 #endif
177
178 /* The hose list.  */
179 extern struct pci_controller *hose_head, **hose_tail;
180 extern struct pci_controller *pci_isa_hose;
181
182 /* Indicate that we trust the console to configure things properly.  */
183 extern int pci_probe_only;
184
185 extern unsigned long alpha_agpgart_size;
186
187 extern void common_init_pci(void);
188 extern u8 common_swizzle(struct pci_dev *, u8 *);
189 extern struct pci_controller *alloc_pci_controller(void);
190 extern struct resource *alloc_resource(void);
191
192 extern struct pci_iommu_arena *iommu_arena_new_node(int,
193                                                     struct pci_controller *,
194                                                     dma_addr_t, unsigned long,
195                                                     unsigned long);
196 extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *,
197                                                dma_addr_t, unsigned long,
198                                                unsigned long);
199 extern const char *const pci_io_names[];
200 extern const char *const pci_mem_names[];
201 extern const char pci_hae0_name[];
202
203 extern unsigned long size_for_memory(unsigned long max);
204
205 extern int iommu_reserve(struct pci_iommu_arena *, long, long);
206 extern int iommu_release(struct pci_iommu_arena *, long, long);
207 extern int iommu_bind(struct pci_iommu_arena *, long, long, unsigned long *);
208 extern int iommu_unbind(struct pci_iommu_arena *, long, long);
209
210