Firmware now works with older Chipcon radios.

[goodfet] / client / goodfet.monitor

diff --git a/client/goodfet.monitor b/client/goodfet.monitor
index ac25c70..ee5a97f 100755 (executable)
--- a/client/goodfet.monitor
+++ b/client/goodfet.monitor
@@ -15,13 +15,36 @@ if(len(sys.argv)==1):
     print "%s verify $foo.hex [0x$start 0x$stop]" % sys.argv[0];
     print "%s ramfill" % sys.argv[0];
     print "%s ramdepth" % sys.argv[0];
     print "%s verify $foo.hex [0x$start 0x$stop]" % sys.argv[0];
     print "%s ramfill" % sys.argv[0];
     print "%s ramdepth" % sys.argv[0];

+    print "%s info" % sys.argv[0];
+    print "%s call 0x$start" % sys.argv[0];
+    print "%s exec '0x35 0x00 0x..'" % sys.argv[0];

     sys.exit();
 
 #Initailize FET and set baud rate
 client=GoodFET();
 client.serInit()
 
     sys.exit();
 
 #Initailize FET and set baud rate
 client=GoodFET();
 client.serInit()
 

+if(sys.argv[1]=="on"):
+    client.dir(0xFF);
+    client.out(0xFF);
+if(sys.argv[1]=="off"):
+    client.out(0x00);

 
 

+if(sys.argv[1]=="call"):
+    adr=int(sys.argv[2],16);
+    print "Calling %04x" % adr;
+    client.call(adr);
+if(sys.argv[1]=="exec"):
+    code="";
+    for foo in sys.argv[2].split(" "):
+        code+=chr(int(foo,16));
+    code+="\x30\x41";
+    client.execute(code);
+    
+if(sys.argv[1]=="info"):
+    a=client.peekbyte(0xff0);
+    b=client.peekbyte(0xff1);
+    print "GoodFET with %02x%02x MCU" % (a,b);

 if(sys.argv[1]=="ramfill"):
     client.monitor_ram_pattern();
 if(sys.argv[1]=="ramdepth"):
 if(sys.argv[1]=="ramfill"):
     client.monitor_ram_pattern();
 if(sys.argv[1]=="ramdepth"):