Add note about another tested PIC target: PIC24FJ64GA002

[goodfet] / firmware / include / platform.h

diff --git a/firmware/include/platform.h b/firmware/include/platform.h
index b315d90..134a082 100644 (file)
--- a/firmware/include/platform.h
+++ b/firmware/include/platform.h
@@ -1,16 +1,50 @@
-//! \file platform.h
+/*! \file platform.h
+  \author Travis Goodspeed
+  \brief Port and baud rate definitions.
+  
+  The functions specified here are defined in the platform
+  definition file, such as msp430x1612.c or msp430x2618.c.
+*/
 
 
-unsigned char serial_rx();
-void serial_tx(unsigned char);
-void setbaud(unsigned char);
-void msp430_init_uart();
-void msp430_init_dco();
+#include "gfports.h"
+
+#include <signal.h>
+#include <io.h>
+#include <iomacros.h>
+
+#include "config.h"
+
+#ifdef telosb
+//TelosB uses second serial port.
+#define serial_tx serial1_tx
+#define serial_rx serial1_rx
+#define setbaud setbaud1
+#define msp430_init_uart msp430_init_uart1
+#else
+//Other targets use first.
+#define serial_tx serial0_tx
+#define serial_rx serial0_rx
+#define setbaud setbaud0
+#define msp430_init_uart msp430_init_uart0
+#endif
 
-//LED on P1.0
-#define PLEDOUT P1OUT
-#define PLEDDIR P1DIR
-#define PLEDPIN 0x1
+unsigned char serial0_rx();
+void serial0_tx(unsigned char);
 
+unsigned char serial1_rx();
+void serial1_tx(unsigned char);
 
+void setbaud0(unsigned char);
+void setbaud1(unsigned char);
+
+//! Initialize the UART
+void msp430_init_uart0();
+//! Initialize the UART
+void msp430_init_uart1();
+
+//! Initialize the DCO Clock
+void msp430_init_dco();
+//! Called by monitor() when the DCO is correct and communication established.
+void msp430_init_dco_done();