Moved board definition from apimote to apimote1 for versioning support.

[goodfet] / firmware / include / platform.h

diff --git a/firmware/include/platform.h b/firmware/include/platform.h
index 5de88ca..2614ecc 100644 (file)
--- a/firmware/include/platform.h
+++ b/firmware/include/platform.h
@@ -1,52 +1,70 @@
 /*! \file platform.h
   \author Travis Goodspeed
   \brief Port and baud rate definitions.
-  
+
   The functions specified here are defined in the platform
   definition file, such as msp430x1612.c or msp430x2618.c.
 */
 
-#include <signal.h>
-#include <io.h>
-#include <iomacros.h>
+#ifndef __PLATFORM_H
+#define __PLATFORM_H
 
 
-//Use P3 instead of P5 for target I/O on chips without P5.
-#ifndef __MSP430_HAS_PORT5__
-#ifndef __MSP430_HAS_PORT5_R__
-#warning "No P5, using P3 instead.  Will break 2618 and 1612 support."
-#define P5OUT P3OUT
-#define P5DIR P3DIR
-#define P5REN P3REN
-#define P5IN P3IN
+#include "gfports.h"
 
-#endif
+#include <stdint.h>
+
+#ifdef MSP430
+#ifdef __MSPGCC__
+#include <msp430.h>
+#else
+#include <signal.h>
+#include <msp430.h>
+#include <iomacros.h>
 #endif
 
-//Use false P5REN for 1612.
-#ifdef __MSP430_HAS_PORT5__
-#ifndef __MSP430_HAS_PORT5_R__
-#warning "1xx, using fake P5REN for external pulling resistors."
-#define P5REN P5OUT
+void msp430_init();
+void led_init();  //deprecated
+void led_on();
+void led_off();
+void led_toggle();
 #endif
+
+#include "config.h"
+
+#ifdef useuart1
+//TelosB and the ApiMote use the second serial port.
+#define serial_tx serial1_tx
+#define serial_rx serial1_rx
+#define setbaud setbaud1
+#define msp430_init_uart msp430_init_uart1
+#else
+//Other targets use first uart.
+#define serial_tx serial0_tx
+#define serial_rx serial0_rx
+#define setbaud setbaud0
+#define msp430_init_uart msp430_init_uart0
 #endif
 
-unsigned char serial_rx();
-void serial_tx(unsigned char);
+unsigned char serial0_rx();
+void serial0_tx(unsigned char);
 
 unsigned char serial1_rx();
 void serial1_tx(unsigned char);
 
-void setbaud(unsigned char);
+void setbaud0(unsigned char);
 void setbaud1(unsigned char);
 
 //! Initialize the UART
-void msp430_init_uart();
+void msp430_init_uart0();
+//! Initialize the UART
+void msp430_init_uart1();
+
 //! Initialize the DCO Clock
 void msp430_init_dco();
+//! Called by monitor() when the DCO is correct and communication established.
+void msp430_init_dco_done();
+
 
-//LED on P1.0
-#define PLEDOUT P1OUT
-#define PLEDDIR P1DIR
-#define PLEDPIN 0x1
+#endif