Added LED test into monitor, supporting increased LEDs on the apimote and telosb...

[goodfet] / firmware / include / platform.h

diff --git a/firmware/include/platform.h b/firmware/include/platform.h
index 113549c..4476724 100644 (file)
--- a/firmware/include/platform.h
+++ b/firmware/include/platform.h
@@ -1,33 +1,76 @@
 /*! \file platform.h
   \author Travis Goodspeed
   \brief Port and baud rate definitions.
-  
+
   The functions specified here are defined in the platform
   definition file, such as msp430x1612.c or msp430x2618.c.
 */
 
-#include <signal.h>
-#include <io.h>
-#include <iomacros.h>
+#ifndef __PLATFORM_H
+#define __PLATFORM_H
+
 
 #include "gfports.h"
 
-unsigned char serial_rx();
-void serial_tx(unsigned char);
+#include <stdint.h>
+
+#ifdef MSP430
+ #ifdef __MSPGCC__
+  #include <msp430.h>
+ #else
+  #include <signal.h>
+  #include <msp430.h>
+  #include <iomacros.h>
+ #endif
+
+ void msp430_init();
+ void led_init();  //deprecated
+ void led_on();
+ void led_off();
+ void led_toggle();
+ #if defined telosb || defined apimote
+  void led2_on();
+  void led2_off();
+  void led3_on();
+  void led3_off();
+ #endif
+#endif
+
+#include "config.h"
+
+#ifdef useuart1
+//TelosB and the ApiMote use the second serial port.
+#define serial_tx serial1_tx
+#define serial_rx serial1_rx
+#define setbaud setbaud1
+#define msp430_init_uart msp430_init_uart1
+#else
+//Other targets use first uart.
+#define serial_tx serial0_tx
+#define serial_rx serial0_rx
+#define setbaud setbaud0
+#define msp430_init_uart msp430_init_uart0
+#endif
+
+unsigned char serial0_rx();
+void serial0_tx(unsigned char);
 
 unsigned char serial1_rx();
 void serial1_tx(unsigned char);
 
-void setbaud(unsigned char);
+void setbaud0(unsigned char);
 void setbaud1(unsigned char);
 
 //! Initialize the UART
-void msp430_init_uart();
+void msp430_init_uart0();
+//! Initialize the UART
+void msp430_init_uart1();
+
 //! Initialize the DCO Clock
 void msp430_init_dco();
+//! Called by monitor() when the DCO is correct and communication established.
+void msp430_init_dco_done();
+
 
-//LED on P1.0
-#define PLEDOUT P1OUT
-#define PLEDDIR P1DIR
-#define PLEDPIN 0x1
+#endif