<> 1. What's this? This is Workbit corp.'s(http://www.workbit.co.jp/) NinjaSCSI-32Bi (http://www.workbit.co.jp/ts/z_njsc32bi.html) PCMCIA card and NinjaSCSI-32UDE PCI card driver module for Linux. 2. Install [1] This driver requires Kernel 2.4.x/2.6.x or later. And you want to load the module when Ninja card was inserted, you also install "hotplug" (http://linux-hotplug.sourceforge.net/) utility. [2] Insert Ninja card to your PC, and check your card is NinjaSCSI-32Bi/UDE card. # lspci .... 01:00.0 SCSI storage controller: I-O Data Device, Inc. CBSC-II duo SCSI PCMCIA card (rev 01) [3] This driver requires Kernel 2.4/2.6's source code. Please install cernel source code. [4] Please check your kernel have PCI, CardBus, PCMCIA and SCSI support. If not, rebuild your kernel. And also requires PCMCIA-CS if you use CardBus card. [5] Extract this archive somewhere. [6] Edit "Makefile" and type "make" to compile the driver. [7] Copy "nsp32.o" to /lib/modules//kernel/driver/scsi/pcmcia/ . [8] Type "depmod -ae" to re-made "/lib/modules//modules.pcimap" [9] Ok. Now you can use Ninja card in CardBus mode. Check your Ninja card is in CardBus mode, and insert the card to PC card slot. 3. Caution If you eject card when doing some operation for your SCSI device or suspend your computer, you encount some *BAD* error like disk crash. It works good when I using this driver right way. But I'm not guarantee your data. Please backup your data when you use this driver. 4. Copyright. No, no, this is Copyleft software. See GPL. YOKOTA Hiroshi