bug fix for the power-supply firmware

[digitaldcpower] / hardware_settings.h-20V-1A

diff --git a/hardware_settings.h-20V-1A b/hardware_settings.h-20V-1A
deleted file mode 100644 (file)
index cce3cf7..0000000
--- a/hardware_settings.h-20V-1A
+++ /dev/null
@@ -1,56 +0,0 @@
-/*
- * Hardware settings for the digital dc power supply
- * http://www.tuxgraphics.org/electronics/
- *
- * In this file you can:
- * - calibrate the ampere and voltmeter
- * - choose your hardware type: 22V 2.5A or 30V 2.0A
- *
- *   The ADC has a resolution of 11 bit = values from 0-2047
- */
-#ifndef CAL_HW_H
-#define CAL_HW_H
-
-
-/* ================= uncomment this section for the model 22V 2.5A */
-
-#define U_MAX 200
-#define I_MAX 100
-
-// internal adc ref voltage (should be 2.56V, can vary from uC to uC)
-#define ADC_REF 2.56
-
-// the divider R3/R4 [(R3+R4)/R4] (calibrate the voltmeter, lower value=higher output)
-#define U_DIVIDER 10.75
-
-// the shunt for current measurement, you can calibrate here the 
-// amperemeter.
-// 2*1.5Ohm 3W=0.75:
-#define I_RESISTOR 0.79
-// short circuit protection limit (do not change unless you know what you do):
-// 850=2.85A= (2.85A * 1023 * 0.75 / 2.56 )
-#define SH_CIR_PROT 850
-
-/* ================= uncomment this section for the model 30V 2.0A */
-
-
-//#define U_MAX 300
-//#define I_MAX 200
-
-// internal adc ref voltage (should be 2.56V, can vary from uC to uC)
-//#define ADC_REF 2.56
-
-// the divider R3/R4 [(R3+R4)/R4], you can calibrate here the voltmeter:
-//#define U_DIVIDER 13.24
-
-// the shunt for current measurement, you can calibrate here the 
-// amperemeter.
-// 2*1.5Ohm 3W=0.75:
-//#define I_RESISTOR 0.78
-
-// short circuit protection limit (do not change unless you know what you do):
-// 690=2.30A= (2.30A * 1023 * 0.75 / 2.56 )
-//#define SH_CIR_PROT 690
-
-#endif //CAL_HW_H
-